Advertisement
8
AI
AR
26
X
32
AQ
38
N
4 PLACES
AC
O
4 PLACES
45
46
R
AH
AG
9
2
L
46
11. Place Weight Stack Support(9), Rubber Cushion 10-1/4"(AG) & two(2) Rubber Cushions 3/4"thk x
2"(AH) over holes in the base of the Rear Upright(2) and slide both Guide Rods(26) into them. NOTE: For
improved performance, we recommend you apply a silicone lubricant to the guide rods prior to their installation.
12 . Leaning the Guide Rods(26) toward you, slide the fifteen(15) Weight Stack Plates(38) onto Guide
Rods(26).
13. Slide the Weight Stack Selector Rod Assembly(32) over the Guide Rods(26) and onto the Weight Stack
Plates(38).
14. Slide the Plastic Rod Support(AI) onto Guide Rods(26) and bolt to the Upper Guide Rod Support(8).
Tighten the three (3) bolts holding the Upper Guide Rod Support(8) which were previously left loose on Pg 5.
15. Install Edge Trim 20-1/4"(AQ) on Weight Stack Shroud(45) & two(2) Edge Trims 36"(AR) on Wt. Stack
Front Shrouds R&L(46).
16. Bolt Weight Stack Shroud(45) and Wt. Stack Front Shrouds R&L(46) to Rear Upright(2) using bolting
7
shown. Install 2" Plastic Cap(AC) where shown.
Advertisement
