Advertisement
AF
39
30. Attach the Back Rest Small(41) to the Back Rest Support(21) then attach them to the Main Upright(6)
making sure that the back adjustment tab is positioned in the main upright openings.
31. Attach the Back Rest Large(42) and the Seat Pad(43) to the Seat Support Assy(10).
32. Select the location for the Leg Extension Roller Tube(44). Slide on all Foam Rollers(39) and Foam Rollers
5"(40). Insert the Foam Roller Caps(AF).
33. Slide on the Rubber Grips(AN & AO) where shown. Grips slide on easiest when a solution of soapy water
is first applied to the bar. This will dry in a short time and causes no damage to the machine. Do NOT use any other
lubricant.
NOTE: Make certain that all cables are properly positioned on/around pulleys before use and that all
nuts have been tightened.
Cables are a consumable and must be treated as such. As a minimum, an annual inspection must
be performed on all cable ends and full lengths. A cable must be replaced immediately if broken
exposed wires and/or a break in cable coating are found.
AO
37
40
AF
J
AN
41
AN
42
43
10
44
6
A
21
L
A
AN
AF
AO
12
AO
AF
40
AN
AO
36
Advertisement
