Table of Contents
Advertisement
1.5.4
Securing the device with clamps
You require 6 clamps in order to mount the device with a 12"/15" display. A device with a 19"
display must be mounted with 8 clamps. The required number of clamps is included in your
Panel PC delivery package.
Required tool for fastening the clamps: Allen wrench 2.5 mm
Figure 1-3
Clamp assembly
Rack installation
Steps for securing the device with clamps
1
2
3
Swivel arm installation
Steps for securing the device with clamps
1
2
3
Control cabinet installation
Steps for securing the device with clamps
1
2
3
SIMATIC Panel PC 577
Operating Instructions, Release 04/2006, A5E00795255
Disconnect the device from the power supply.
Working from the front, insert the device into the 19" rack.
Fasten the control unit in the rack from the rear using the clamps. Tighten the setscrews to a
torque of 0.4-0.5 Nm.
Disconnect the device from the power supply.
Working from the front, place the device onto the swivel arm.
Fasten the control unit on the swivel arm from the rear using the clamps. Tighten the setscrews
to a torque of 0.4-0.5 Nm.
Disconnect the device from the power supply.
Working from the front, insert the device into the mounting cut-out.
Secure the control unit in the mounting cut-out from behind with the clamps, as shown in the
mounting cut-out in the dimensions. Tighten the setscrews to a torque of 0.4-0.5 Nm.
Operating Instructions (compact)
1.5 Mounting / panel-mounting
1-5
Advertisement
Table of Contents
