Z-Wave Setup; Adding Z-Wave Devices - Honeywell TUXWIFIS Installation And Setup Manual

Adding Z-Wave Devices

Before a Z-Wave device will work in the home control network, it must be added (also called included)
into the network. View the "Programming of Z-Wave Devices" training video and follow the instructions
below to add and control devices in a home control network.
If additional Z-Wave compatible devices are purchased, new devices can be added into the home network
at any time.
Add a Light, Switch or Outlet Module
1. Install device according to the manufacturer's directions.
2. Press the Automation
3. Be sure the power switch on the device module is ON and press the Function Key on the device; follow
the on-screen messages until
NOTES:
• If a dimmer module was added, an On/Off button and a slide bar (to control the dimmer) are
displayed.
• If an on/off light, appliance, switch or outlet module was added, an On/Off button (to control the
device) is displayed.
• Automation functionality is supplementary only and has not been evaluated by UL.
U L
• Z-Wave applications have not been evaluated by UL.
Access control functionality has not been evaluated by UL and may not be used in UL Listed applications.
•
WARNING: Automation is intended for lifestyle convenience. Do not use automation for life safety and
property protection.
Add a Door Lock
1. Assemble the Z-Wave door lock according to the manufacturer's directions. Be sure the door lock
orientation/handedness is correct.
2. Refer to the Door Lock Instructions and connect necessary cables, then install batteries.
3. Enroll the door lock within 5 feet of the Tuxedo; refer to the Door Lock's Instructions Guide for
procedure.
NOTE: Program a 4-digit user code in the control panel prior to programming that user code into the
door lock.
4. Press the Automation
5. On the door lock, program the selected user code from the panel.
6. Follow the on-screen messages until "Device added successfully".
NOTE: If Tuxedos software is upgraded, enroll the door lock again and re-set the user code in the door
lock.

Z-Wave Setup

, Z-Wave Setup and Z-Wave Add Device
"Device added successfully".
, Z-Wave Setup and Z-Wave Add Device
33
icons.
icons.