Troubleshooting; Problems And Solutions - Kyocera FineCam SL300R Instruction Manual

Check the items listed below before deciding that your camera is faulty.

Problems and Solutions

Problem
Nothing appears on
the LCD monitor.
There is no image on
the LCD monitor.
The number of
available shots did not
change when I took a
picture.
I cannot erase an
image. The [ ] icon
appears.
I cannot erase an
image.
7
The number of
available shots did not
increase after I erased
an image.
I cannot charge the
battery.
I cannot charge the
battery. Or charging
stops. The caution
LED flashes slowly.
7-2

Troubleshooting

Cause
The lithium-ion battery pack is flat or is
not inserted.
The Power Save function has
switched the camera off. (
If you leave the camera for a while
without using it, the camera goes into
Sleep mode.
There is something generating a
magnetic field (such as a magnet or
TV) close to the camera.
This is because the photographed
image size is small.
The image is protected.
The image file was recorded using a
different device.
This is because the erased image size
is small.
There is no lithium-ion battery pack
loaded in the camera.
The lithium-ion battery pack poles
(+ and –) are the wrong way round.
The AC adapter is not connected
correctly.
The battery pack terminals are soiled. Wipe the terminals with a soft clean
The charging protection circuit was
activated and halted charging
because the ambient temperature is
too high or too low.
Load a lithium-ion battery pack into
the camera and re-charge it.
Press the POWER button
p.6-6) to switch the camera back on.
Press the shutter release button half
way or press any other camera button
to restore the camera to Shooting
mode. The details vary depending on
the Power Save function settings. See
p.6-6 for details.
Move the camera further away from
the magnetic object.
This is dependent on factors such as
the quality mode and the subject and
is not a problem.
Unprotect the image. (
The image cannot be erased using
this camera. You can use FORMAT to
erase the image, but this will erase all
the images on the card. (
This is dependent on factors such as
the quality mode and the subject and
is not a problem.
Load a lithium-ion battery pack into
the camera.
Reload the lithium-ion battery pack
correctly.
Check that the adapter is securely
connected to the camera and the
power socket.
cloth.
Charge the battery when the ambient
temperature is between 10°C and
30°C. (Charging is possible between
5°C and 40°C but will take slightly
longer.)
Solution
again
H
p.5-9)
p.6-5)