Blaupunkt LS175 Owner's Manual page 5

LS175
Unauthorized substitutions may result in fire, electric shock or other hazards.
22. Mains fuses - For continued protection against fire hazard, use fuses only
of the correct type and rating. The correct fuse specification for each voltage
range is marked on the product.
23. Do not turn up the volume while listening to a section with very low level
inputs or no audio signals. If you do, the speaker may be damaged when a peak
level section is suddenly played.
24. The only means of completely disconnecting the product from the power
supply is by removing the power cord from the wall outlet or the product. The
wall outlet or the power cord entry to the product must remain freely
accessible at all times while the product is in use.
25. Try to install the product near a wall socket or extension cord and shall be
easily accessible.
26. The highest environmental temperature suitable for this product is 35°C.
27. ESD hints - The normal function of the product may be disturbed by strong
Electro-Magnetic Interference. If so, simply reset the product to resume
normal operation by following the instruction manual. In case the function
could not resume, please use the product in other location.
28. Battery
1). The batteries must not be exposed to excessive heat such as sunshine, fire
or the like.
2). The batteries should be drawn to the environmental aspects of battery
disposal.
3). Battery usage CAUTION-to prevent battery leakage which may result in
body injuries, property damage, or damage to the apparatus:
- Install all batteries correctly, + and – as marked on the apparatus.
- Do not mix batteries (old and new or carbon and alkaline, etc.)
- Remove batteries when the unit is not used for a long time.
ERP2 - (Energy Related Products) note
This product with ecodesign complies with the stage 2 requirements of
Commission Regulation (EC) NO. 1275/2008 implementing Directive
2009/125/EC regard to standby and off mode electric power consumption of
electronic household and office equipment. After 60 minutes without any
audio input, the device will automatically switch into standby mode. Follow up
the instruction manual to resume the operation.
Important note:
This device is equipped with an energy saving mode: if no signal is given
during 60 minutes the device will switch automatically into standby mode in
order to save energy (ERP 2 standard). Please note that low volume setting in
4