Instruction For Setting The Built In Clock; General Layout; To Set The Time; To Set The "On" And "Off" Times - Chaffoteaux & Maury Britony SE 80 Nat Operating Instructions Manual

Instruction for Setting the Built in Clock

11
(if fitted)

1. General layout

The mechanical clock covers a 24 hour period. Each tappet
represents 15 minutes A (fig. 25). An override switch is
located on the clock B (fig 25).

2. To set the time

To set the time of day, grasp the outer edge of the dial and
turn slowly clockwise until the correct time is lined up with
the arrow C (fig. 25).

3. To Set the "On" and "Off" times

The clock uses a 24hours system. e.g. 8 =8.00 am and
18 = 6.00 pm "ON" periods are set by sliding all tappets
between the "ON" time and the "OFF" time to the outer edge
of the dial.The tappets remaining at the centre of the dial are
the "OFF" periods.
Fig. 24

4. To select function mode

Put the selector switch B to symbol to control the boiler
by the clock. Put the switch B to «I» to select permanent
operation or to «0» to turn heating off permanently.
A
1 1
C
I
B
Fig. 25
14