GE Kilsen KFP-CF Series Operation Manual page 10

Item Control/LED
10 General Disable
button and LED
11 General Test button
and LED
12 Numeric keypad and
Enter button
13 Reset button
14 Panel Silence button
and LED
15 Sounder Start/Stop
button and LED
16 System Fault LED
17 Out of Service LED
18 Earth Fault LED
19 Supply Fault LED
20 Fire Routing Delay
button and LED
21 Fire Routing Start
button and LED
6
LED colour Description
Yellow Disables a zone, sounders, fire routing, or expansion
I/O module (when pressed with the corresponding
button).
A steady general Disable LED and the corresponding
zone, sounders, or fire routing Fault/Disable/Test
LED indicates a disablement.
Yellow Tests a zone, sounders, or fire routing (when pressed
with the corresponding button).
A steady general Test LED and the corresponding
zone, sounders, or fire routing Fault/Disable/Test
LED indicates a test.
N/A Used to enter the access level 2 password. The Enter
button is also used to disable expansion I/O modules
(when pressed with the general Disable button).
Yellow Resets the control panel and clears all current
system events (except expansion I/O module fault
communication).
A steady LED indicates that access level 2 is active
(see "Access levels" on page 10).
Yellow Silences the internal buzzer and acknowledges all
current events.
A steady LED indicates that all current events were
acknowledged.
Red Stops (silences) all active sounders. Pressing the
button again restarts them.
A flashing LED indicates that sounders activate
when a configured delay elapses. A steady LED
indicates that the sounders are active (sounding).
Yellow Indicates a control panel CPU failure.
Yellow Indicates that the control panel is not operational.
Yellow Indicates an earth fault.
Yellow Indicates a fault with the power supply.
A flashing LED indicates a battery or battery fuse
fault. A steady LED indicates a mains or mains fuse
fault.
Yellow Enables or disables a previously configured fire
routing delay.
A steady LED indicates that a fire routing delay is
configured and enabled.
Red Cancels a previously configured delay and activates
fire routing.
A flashing LED indicates that fire routing activates
when the configured delay elapses. A steady LED
indicates that fire routing is active.
Kilsen KFP-CF Series Operation Manual