Removing The Optical Drive; Replacing The Optical Drive - Dell Studio 1435 Service Manual

Back to Contents Page
Optical Drive
Dell Studio™ 1435 Service Manual
Removing the Optical Drive
Replacing the Optical Drive
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
Removing the Optical Drive
1. Follow the instructions in Before You
2. Follow the instructions in Removing the Palm
3. Remove the two screws that secure the optical drive to the computer base.
4. Release the connector latch to disconnect the optical drive cable from the system board connector.
5. Lift the optical drive out of the computer base.
1 connector latch
3 screw (2)
Replacing the Optical Drive
1. Place the optical drive back in position and replace the two screws that secure the optical drive to the computer base.
2. Connect the optical drive cable to the system board connector.
3. Follow the instructions in Replacing the Palm
Back to Contents Page
Begin.
Rest.
2 optical drive
Rest.