Display Assembly; Removing The Display Assembly - Dell Studio 1435 Service Manual

Back to Contents Page
Display
Dell Studio™ 1435 Service Manual
Display Assembly
Display Bezel
Display Panel
Display Panel Cable
Inverter Board
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as a connector on the back of the computer).
NOTICE: To help prevent damage to the system board, you must remove the battery from the battery bay before you begin working inside the
computer.
Display Assembly

Removing the Display Assembly

1. Follow the instructions in Before You
2. Remove the center control cover (see
3. Remove the base cover (see
4. Remove the keyboard (see
5. Remove the palm rest (see
6. Remove the optical drive (see
7. Remove the two screws from the computer base.
8. Make note of the routing guides and remove the antenna cables.
1 WLAN antenna cables
9. Remove the screw that secures the display cable and disconnect the cable from the system board connector.
10. Disconnect the camera cable (optional) and the power button cable.
Begin.
Removing the Center Control
Removing the Base Cover).
Removing the Keyboard).
Removing the Palm Rest).
Removing the Optical Drive).
2 WPAN antenna cable
Cover).