HEAD ADJUSTMENTS
Tilting the Drill Press Head 45
90
Counterclockwise
o
1. Loosen the lock handle (A-Fig.19) on the right
side of the drill press head.
2. Pull the guide pin out on the left side of the
drill
press head (A-Fig.20) and rotate 90
head
may be tilted to the desired angle.
3. Tighten the lock handle.
4. To return to the original position, loosen the lock
handle.
5. Move the head back to a vertical position .
6. Pull the guide pin out and rotate until it seats in the
guide pin slot.
7. Tighten the lock handle.
Adjusting the Drill Press Head Forward and
Backwards
1. Loosen the lock handle on the right side of the
head.
2. Turn the handle (A-Fig.21,22 ) to the desired
position.
3. Tighten the lock handle.
Adjustment and Operation
Clockwise and
o
A
Figure 21
. The
o
11
A
Figure 19
A
Figure 20
A
Figure 22