Setting The Spindle Lock; Setting The Drill Depth - Rikon Power Tools 30-140 Manual

CHANGING SPINDLE SPEEDS CONT.
6. Place the belt on the pulleys in relation to the
speed chosen on the speed selection chart
starting with the motor pulley first. (Fig.27)
7. Push back on the motor until there is approxi
mately 1/2" deflection in the belt. (Fig.28)
8. Tighten the belt tension lock handle.
9. Close the belt guard.
10. Reconnect the Drill Press to the power.

SETTING THE SPINDLE LOCK

1. Loosen the depth stop collar lock (A-Fig.29) as
shown.
2. Lower the spindle to the desired depth. (Fig.30)
3. Turn the depth stop collar clockwise until the
collar
stops (B-Fig.29).
4. Tighten the depth stop collar lock.
NOTE:
Figure 30 shows the spindle in the locked
position.

SETTING THE DRILL DEPTH

1. With the spindle in the up position, loosen the
depth
stop collar lock (A-Fig.29) as shown.
2. Turn the depth stop collar clockwise until the
pointer reads the desired drill depth on the
scale
(B-Fig.29).
4. Tighten the depth stop collar lock.
13
Figure 27
Figure 28
A
B
Figure 29
Figure 30