TABLE ADJUSTMENTS
Raising and Lowering the Table
1. Loosen the column lock (A-Fig. 19) on the
table support bracket (B-Fig. 19).
2. Turn the crank to raise or lower the table to the
desired height.
3. Tighten the column lock (A-Fig. 19).
The table can rotate 360
lock handle and turning to the desired position.
(Fig. 20)
TILTING THE TABLE
1. Loosen the nut below the table. (Fig. 21)
2. Tilt table to desired angle.
3. A tilt scale and pointer are provided on the
bracket to indicate the angle.
4. Tighten nut.
CHANGING SPINDLE SPEEDS
WARNING!
Disconnect machine from the power source.
1. Turn off and disconnect the power to the Drill
Press.
2. Open belt cover.
3. Release the tension on the belt by loosening
the belt tension lock (A-Fig. 22) and pull the
tension handle backward on the motor (B-Fig.
22).
4. Choose the desired speed by referring to the
speed selection chart.
o
by loosening the table
A
A
B
11
B
Figure 19
Figure 20
Figure 21
Figure 22