Table of Contents
Advertisement
REMOVING THE CHUCK
1. Open the chuck jaws as wide as possible to
prevent damage.
2. Lower the spindle until the slot in the spindle is
exposed. (Fig.14)
3. Position the table approximately 1/2" below
the
extended chuck.
4. Turn the chuck until a through hole is exposed
in the spindle.
5. Insert the Key-drift provided into the slot.
(Fig.15)
6. Gently tap the key-drift with a mallet to release
INSTALLING THE TABLE
1. Install the arm onto the table support with hex
bolt(A-Fig.16) and make sure the scale is on
zero position(B-Fig.16). If necessory, adjust the
hex socket screw (C-Fig.16) to lever the table
90 degree to the spindle.
B
2. Insert the table post (A-Fig.17) into the table
support bracket (B-Fig.17) as shown.
3. Tighten the locking lever (A-fig.18) onto the
table support bracket (B-Fig.18) and install the
table raising/lowering handle (C-Fig.18).
A
C
Figure 16
A
B
A
10
B
Figure 14
Figure 15
A
B
Figure 17
C
Figure 18
Advertisement
Table of Contents
