Power Management; Screen Blank Mode (For Windows 7 Only); Sleep Mode - ThinkPad T440p Hardware Maintenance Manual

Table of Contents

Advertisement

To remove a user hard disk password that has been forgotten, when the supervisor password and master
hard disk password are known, do the following:
1. Turn on the computer.
2. When the logo screen comes up, immediately press F1 to enter the ThinkPad Setup program.
3. Select Security.
4. Select Password.
5. Select Hard-disk x password, where x is the letter of the hard disk drive. A pop-up window opens.
6. Select Master hard disk password.
7. Type the current master hard disk password in the Enter Current Password field. Then leave the Enter
New Password field blank, and press Enter twice.
8. Press F10.
9. Press F10 to save changes and exit the ThinkPad Setup program. The user hard disk password and the
master hard disk password have been removed.

Power management

To reduce power consumption, the computer has three power management modes: screen blank, sleep,
and hibernation.

Screen blank mode (for Windows 7 only)

If the time set on the "Turn off monitor" timer in the operating system expires, the LCD backlight turns off.
To put the computer into screen blank mode, do the following:
1. Right-click the battery gauge on the taskbar.
2. Select Power off display.
To end screen blank mode and resume normal operation, press any key.

Sleep mode

When the computer enters sleep mode, the following events occur in addition to what occurs in screen
blank mode:
• The LCD is powered off.
• The hard disk drive or solid-state drive is powered off.
• The microprocessor stops.
To put your computer into sleep mode, press Fn+4 or do the following:
• For Windows 7: Click the arrow beside the Shut down icon, and then select Sleep. To return from
sleep mode, press the Fn key.
• For Windows 8 and Windows 8.1: Move the pointer to the bottom-right corner of the screen to display the
charms. Then click Settings ➙ Power ➙ Sleep.
To return to normal operation, press the Fn key only.
In certain circumstances, the computer goes into sleep mode automatically:
• After a period of inactivity specified in power plan settings
• When the battery power is low
.
Chapter 4
Related service information
35

Advertisement

Table of Contents
loading

Table of Contents