AGFA Ovation! Operator's Manual page 18

1.9.2 Media Width Adjustment
The thumbwheel on the side of the printhead carrier assembly
allows the printhead to be adjusted for various sizes of media. The
numbers on the thumbwheel serve only as a reference point and do
not correspond with a particular media width.
Figure 1-11 Thumbwheel for Media Width Adjustment
1. Load media into the printer.
2. Print a label, if it is light on the right-hand side then move the
thumbwheel to the right, (see example below).
3. An internal test label can be generated by holding the 'feed' button
down and turning 'on' the power switch until the media moves. The
first label printed is the configuration label which provides
information on the printer set-up. The second label printed is the
test pattern and shows print quality, (see Section 1-10 for additional
information).
Rotate
thumbwheel
clockwise until
print quality
along edge starts
to lighten.
10
Getting Started
(Light print on
the right side of
the test label
indicates that the
thumbwheel
should be
adjusted
clockwise.)
Ovation!™