Secure Fireplace; Canopy Installation - Majestic DVDNV series Operating Instructions Manual

Designer Series Gas Fireplaces
X
Y
A
Y
A Flat on Wall
B Room Divider
Figure 7 -
Possible Fireplace Locations
a. waLL LoCaTIoN
y Minimum distance between a glass panel and a parallel
FP2277
wall = 4"
locate fireplace
Z Minimum distance between the edge of a glass panel and
an adjacent wall = 3"
B. Island Location
x (Maximum length of horizontal venting = 0'. Refer to the
venting section of this manual for specific dimensions.
SECuRE FIREPLaCE To FLooR
The fireplace must be secured to the floor and/or to framing
studs as shown in Figure 8. Use two () wood screws or
masonry/ concrete screws to secure fireplace to the floor.
Use four (4) screws to attach fireplace to framing. The side
brackets are adjustable from 1/" to 5/8" to accommodate
different thickness of noncombustible material.

CaNoPy INSTaLLaTIoN

1. Unlatch and remove glass door. Refer to Page 7.
. Remove three (3) top louvers by pulling firmly.
3. Locate screws on upper frame and remove.
(Five (5) screws on long side and three (3)
screws on short side.) Figure 9
4. Install canopy hood and secure using
screws previously removed.
5. Reinstall louvers and glass door.
IMPoRTaNT:
Canopy hoods are furnished with this
fireplace and all of them MuST be installed for safe
operation.
10
X
X
B
A
Y
Z
FP77
Screws
Figure 8 -
Secure Fireplace to Floor and Framing Studs
FP2278

secure fireplace

Figure 9 -
Install ALL Canopies
FP2918
canopy install
INSTaLLaTIoN
FP78
FP918
53D0419