Before Installation; System Configuration Verification - Total Protection Solutions ServiceTrack 200 Operating Instructions Manual

1. System Configuration Verification:

BEFORE INSTALLATION

1. System Configuration Verification
Confirm that the voltage(s) and service configuration shown on ServiceTrack product label are consistent with the voltage
and service configuration of the facility. A model number is on the label inside ServiceTrack door. Each model number
corresponds to the configurations printed in the table below:
Example of a suppressor model number: TK-SE200-3Y208-A
MODEL NUMBER
TK-SExxx-1P120
TK-SExxx-1P240
TK-SExxx-1S240
TK-SExxx-3Y208
TK-SExxx-3Y380
TK-SExxx-3Y480
TK-SExxx-3Y600
TK-SExxx-3D240
TK-SExxx-240NN
TK-SExxx-380NN
TK-SExxx-480NN
TK-SExxx-600NN
!
WARNING: Check to ensure that a proper bond is installed between neutral and ground at the transformer
upstream from all 3-phase WYE, 3-phase high-leg DELTA, or split-phase ServiceTrack device (see NEC article 250).
If the transformer is not accessible, check the main service disconnect/panel for the N-G bond. Lack of a proper bond
will damage ServiceTrack and void the warranty.
4
NOMINAL L-N
VOLTAGE VOLTAGE RANGE
120 102-132
240 196-276
120/240 102-132
120/208 102-132
220/380 187-264
277/480 236-305
347/600 295-399
102-132
(A & C PHASES)
120/240
177-229
(B PHASE)
240 N/A
380 N/A
480 N/A
600 N/A
L-L
VOLTAGE RANGE
N/A
N/A
204-264
177-229
323-460
408-528
510-690
Three-Phase high-leg DELTA
204-264
Three-Phase DELTA
204-264
Three-Phase DELTA
323-460
Three-Phase DELTA
408-528
Three-Phase DELTA
510-690
™
SERVICETRACK INSTALLATION, OPERATION AND MAINTENANCE MANUAL
CONFIGURATION
Single-Phase,
2-wire+ground
Single-Phase,
2-wire+ground
Split-Phase,
3-wire+ground
Three-Phase WYE
4-wire+ground
Three-Phase WYE
4-wire+ground
Three-Phase WYE
4-wire+ground
Three-Phase WYE
4-wire+ground
4-wire+ground
3-wire+ground
3-wire+ground
3-wire+ground
3-wire+ground