Toshiba 40L3400U User Manual page 50

50
Setting up your TV
Auto Tuning
To program channels automatically:
1 Configure the antenna input source, if you have not already
done so, see
2 Press the MENU button and open the Installation menu.
3 Highlight Channel Tuning, and then press the OK button.
(Sample Image) Setup menu - Installation selection
4 Highlight Auto Tuning, and then press the OK button to open
the Channel Program menu to begin channel programming.
!
Scanning channels, please wait...
Number of Channels Found -
Scanning Analog Channels
Channel -
(Sample Image) Installation menu - Channel selection
The TV will automatically cycle through all the antenna/cable
channels, and store all active channels in the channel memory.
While the TV is cycling through the channels, the message
"Scanning channels, please wait" appears.
When channel programming is complete, press the CH
▲/▼(arrow) buttons to view the programmed channels.
"ANT/CABLE IN" on page 48.
Network
Cable
9
Cancel
To cancel channel programming, press the EXIT button on the
remote control or highlight Cancel in the on-screen display, and
then press the OK button.
6%
7