NOTE; PERSONAL AND CUSTOM PREFRERENCES WILL BE LOST UPON COMPLETION
OF THIS FIRMWARE UPDATE. PLAEAE MAKE NOTE OF ANY PREFERENCE SETTINGS
PRIOR TO STARTING THIS FIRMWRE UPDATE.
How to upgrade the Software
1
Connect the AC power and turn "ON" the TV receiver.
2
The USB reader is located on the left of the cabinet near the side control/jack assembly as shown in
Figure1.
Copyright 2013
Figure1
All Rights Reserved
Page 1 of 4
Need help?
Do you have a question about the 24W1334G and is the answer not in the manual?
Questions and answers