Disassembling The Reverse Gear; Assembling The Lower Case - Yamaha Z300A Supplementary Service Manual

Disassembling the reverse gear

1. Remove the needle bearing from the
reverse gear using a chisel.

Assembling the lower case

1. Install the needle bearing into the
retainer to the specified depth.
Needle bearing attachment 1:
90890-06654
Driver rod L3 2: 90890-06652
Depth a:
–0.25–0.25 mm (–0.010–0.010 in)
2. Install the original shim(s) and retainer
into the lower case.
6D03F1X
Drive shaft and lower case (counter rotation model)
CAUTION:
Add or remove shim(s), if necessary, if
replacing the forward gear or lower case.
Ball bearing attachment 3:
90890-06657
Driver rod LL 4: 90890-06605
3. Install the needle bearing outer case into
the lower case.
NOTE:
Apply gear oil to the needle bearing outer
case before installation.
Bearing outer race attachment 5:
90890-06628
Bearing outer race puller
assembly 6:
90890-06523
4. Install the needle bearing into the needle
bearing outer case.
NOTE:
Apply gear oil or grease to the needle bear-
ing before installation.
54