Yamaha Z300A Supplementary Service Manual page 77

NOTE:
Wrap the removed pipe joint b in a rag.
PTT oil pressure gauge assembly:
90890-06580
12. Connect the PTT motor leads to the bat-
tery terminals to extend the trim ram, and
then measure the hydraulic pressure.
Hydraulic pressure (up):
11.3–13.3 MPa (113–133 kgf/cm
13. Reverse the PTT motor leads between
the battery terminals to fully retract the
trim and tilt rams.
6D03F1X
14. Remove the oil pressure gauge 2.
15. Install the pipe joint b, and then tighten
the pipe joints to the specified torque.
Pipe joint 3:
16. After measuring the hydraulic pressure,
connect the PTT motor leads to the bat-
tery terminals to fully extend the trim and
tilt rams.
2
)
17. Remove the reservoir cap, and then
check the fluid level in the reservoir.
Power trim and tilt unit
15 N·m (1.5 kgf·m, 11.1 ft·lb)
70