Table of Contents
Advertisement
6
Operating the appliance
Control bar
The control bar is a special Touch Control field. The
control bar is touched where the desired heat set-
ting is positioned. The heat setting is shown in the
display. Correct to the left or the right, if neces-
sary. Do not release before the desired heat setting
is reached.
If the control bar is touched for longer than 6
seconds, a signal sounds and the appliance
switches itself off.
Operating the appliance
Use the induction cooking zones with suitable cookware.
Switching the appliance on and off
Switch on
Switch off
After switching on, within approx. 10 seconds a heat setting or a function must be set,
otherwise the appliance automatically switches itself off.
Setting the heat setting
To set the heat
setting
Switch off
Locking/unlocking the control panel
The control panel, with the exception of the "On/Off" sensor field, can be locked at any time
in order to prevent the settings being changed e.g. by wiping over the panel with a cloth.
To switch on
To switch off
When you switch the appliance off, the locking function is automatically switched off.
Turning the STOP+GO function on and off
The STOP+GO function simultaneously toggles all active cooking zones to keep-warm mode
then back to the heat setting they were at before
Control panel
Touch
for 1 second
Touch
for 1 second
Control panel
Touch the desired heat setting, if necessary, correct
up or down
Touch
Control panel
Touch
previously set heat setting
Touch
Display
/
/ none
(for 4 seconds)
Pilot light
lights up.
goes out.
Display
/
to
Display
P
Advertisement
Table of Contents
