T+A SACD 1260 R User Manual page 50

Problem: The disc will not play once the disc
drawer is closed.
Cause 1:
Disc not inserted correctly.
Remedy: Position the disc centrally: printed face up.
Cause 2: Disc soiled.
Remedy:
Carefully clean the disc by wiping with a
soft cloth from the centre to the edge.
Replace the disc and try again.
Cause 3: Disc damaged in the area of the Table of
Contents (TOC). Disc unusable.
Remedy: No remedy possible.
Cause 4:
Machine has got very cold (e. g. after
transport), allowing condensation to form
on the laser sensor optics.
Remedy: Leave the machine to warm up for about
an hour in a warm, well ventilated place.
Problem: Disc stops playing, or 'skips'.
Cause:
Disc dirty or damaged.
Remedy: Clean disc. Damage cannot be repaired!
Problem: When used in a non- system the
machine does not respond to remote
control commands,
switched on by remote control.
Cause: E 2000 remote control receiver not con-
nected.
Remedy: Connect the
receiver as shown in Wiring Diagram 3.
Press the source select button 
(or   ) on the remote control handset
 
to switch the machine on.
or cannot be
E 2000 remote control

 
Problem:
'
overheat overheat
overheat overheat
Cause: Device is over heated, too little flow of
cooling air
Remedy:
change the installation of your system to
provide sufficient cooling.
do not place the SACD 1260 R on top of
hot equipment like amplifiers or surround
receivers
Problem: Not possible to switch to MCH mode
Cause:
Disc does not contain a multi channel
layer
Remedy: no remedy, disc can only be played back
in Stereo.
Problem: The 'WIDE'-mode can not be selected
Cause: switch 'WIDE' at the back panel is set
position 'Disable'.
Remedy: Set switch to position 'Enable'.
50
' displayed, playback stopped