Trouble-Shooting - T+A SACD 1260 R User Manual

Many problems have a simple cause and a corres-
pondingly simple solution. The following section des-
cribes a few difficulties you may encounter, and the
measures you need to take to cure them.
If you find it impossible to solve a problem with the help
of these notes, please disconnect the unit from the mains
and ask your authorised   specialist dealer for advice.
 
Problem: Machine does not switch on (LED stays
dark).
Cause: Mains lead not connected correctly.
Remedy: Check connection, push in firmly.
Problem: Machine does
buttons are pressed.
Cause:
Static discharge or powerful interference
(e. g. lightning)
processor's memory.
Remedy: Reset machine: disconnect the mains
plug, wait about 10 seconds, then plug in
again. Switch the machine on.
Problem: Machine responds correctly when front
panel buttons are pressed, but cannot
be remote-controlled via an 'R' series
pre-amplifier, integrated amplifier or
receiver.
Cause 1:
Batteries in
exhausted or fitted incorrectly.
Remedy: Fit new batteries, or re-fit batteries with
correct polarity.
Cause 2: R or RC plug not connected correctly
LINK
to machine's R
Remedy:
Complete connections as shown in wiring
diagram; push connector in firmly.
Cause 3: No visual contact between remote control
transmitter and remote control receiver of
the 'R' series pre-amplifier, integrated
amplifier or receiver.
Remedy:
Ensure direct visual contact between
remote control transmitter and receiver
(glass doors may prevent contact).
The maximum range of the remote control
system is about 8 metres.
Position the remote control receiver so
that it is not subjected to direct sunlight or
excessively bright lighting. Fluorescent
lamps and
powerful sources of interference.

Trouble-shooting

not respond when
have affected the
remote control handset
or RC socket.
LINK
energy-saving bulbs are
Cause 4: The CD / SACD player is not selected as
current listening source on the pre-
amplifier, integrated amplifier or receiver,
i. e. the control commands from the
handset are being passed to another 'R'
system device.
Remedy:
Press the 
handset, and try again.
Cause:5: The remote control address of the CD /
SACD player (CD) does not correspond to
the selected audio input sockets on the
pre-amplifier,
receiver.
Remedy: Connect the SACD 1260 R to the correct
input.
Problem: Loud hum from the loudspeakers.
Cause:
Cinch plugs making poor contact, or faulty
Cinch lead.
Remedy: Check all connections and connecting
leads carefully.
Problem: No sound, or distorted sound.
Cause:
Audio connection to amplifier or TV set not
correct.
Remedy: Complete the connections as shown in the
wiring diagram; push connectors in firmly.
Select a different listening source to check
the amplifier.
Problem: No sound signal via the digital output.
Cause 1:
Digital plug not connected correctly to the
digital output socket on the machine.
Remedy:
Complete connections as per wiring
diagram; push connectors in firmly.
Cause 2:
The data format of the selected audio
channel (e. g. Dolby Digital or DTS) is not
recognised by the decoder connected to
the system.
Remedy:
Use a decoder which supports the data
formats.
Problem: Nothing displayed on the screen.
Cause: Screen switched off.
Remedy:
Press   button to switch it on again.
 
49
 on the remote control
 
integrated amplifier or