Technical Cautions - Hitachi 57F59A Service Manual

CAUTIONS WHEN CONNECTING / DISCONNECTING THE HV CONNECTOR
Perform the following when the
HV connector (anode connector)
is removed or inserted for CPT
replacement, etc.
PUSH
PUSH
Fig. A
During Insertion
1. Please refer to direction for insertion as shown in Fig. B (L position). Insert connector until "CLICK" sound is heard.
2. Make sure the connector is pressed right in, so that it has a good contact with the spring.
3. Confirm the contact by pulling the connector slightly. (Don't pull hard because it may damage the connector).
4. Cover the high voltage output by carefully pushing silicon cover onto it. (Don't turn the connector).
(REMARK)
1. Make sure the silicon cover is
covering the high voltage output.
TABLE OF CONTENTS

TECHNICAL CAUTIONS

Deflection P.W.B.
During Removal
1.
2.
3. Remove the connector slowly
by pulling it away from the
case.
FBT
Roll out silicon cover from FBT's contact area slowly.
While turning the connector about 90 degrees
following the arrow (0 position), push the connector
slightly towards the case. (Fig. A)
Silicon cover
Wing
L Position
Silicon Cover
less than 1mm
11
DP65
Anode
connector
Wing
L Position
Fig. B