Stelpro B1T1ER Detailed Installation Instructions

Heater thermostat

Table of Contents

Download this manual

www.stelpro.com

Note that the power supply must come from the right side.

Stelpro Design recommends that the installation of this product be

performed by a certified electrician. Before installing this product,

ensure that the breaker at the electrical panel is switched to the

OFF position.

Make sure that all the electrical connections are secure and have

been made properly. Pull each wire to ensure it is not loose in the

connector or the terminal board as this may cause a fire.

INSTRUCTIONS FOR B BASEBOARD

Right installation only.

For a video of the installation

process, visit our Web site at

www.stelpro.com/en/B1T1ER.php

WARNING

INS-B1T1ER 1112

DETAILED INSTALLATION

HEATER THERMOSTAT (B1T1ER)

Table of Contents

Need help?

Do you have a question about the B1T1ER and is the answer not in the manual?

Page 1 Web site at www.stelpro.com/en/B1T1ER.php WARNING Stelpro Design recommends that the installation of this product be performed by a certified electrician. Before installing this product, ensure that the breaker at the electrical panel is switched to the OFF position.
Page 2 (note that this coverplate will no longer be required as the thermostat is equipped with its own coverplate). Perform the electrical connexions as indicated on the following diagram. Right junction box Boîte de jonction droite INS-B1T1ER 1112...
Page 3 Push down the thermostat until it the screw that has been removed at clips into place (under the metallic step 2. insert located at the right side of the junction box). Do not push it below the second metallic insert. INS-B1T1ER 1112...
Page 4: Limited Warranty
The warranty is limited to the factory repair or the replacement of the unit, and does not cover the cost of disconnection, transport, and installation. Service à la clientèle de Stelpro Design Inc. 1041, rue Parent St-Bruno-de-Montarville (Québec) J3V 6L7 www.stelpro.com...