Safety Decals - Pro-Fab Industries Cozeburn Installation And Operation Instructions Manual

Safety Decals

Please read and follow directions to ensure safe practices when using the Cozeburn furnace.
1) DANGER/WARNING/CAUTION - Located on left hand side of damper.
2) FURNACE SERIAL DECAL - Located on left hand side of furnace.
3) MAX. WOOD FILL TO TOP OF DOOR. - Located on top left hand corner of front door.
4) THIS LID IS HEAVY. USE BOTH HANDS. - Located on back chimney cover.
5) NOTE! MINIMUM 6 FT. OF INSULATED CHIMNEY IS REQUIRED FOR PROPER DRAFT. CLEAN CHIMNEY OUTLET REGULARLY.
COVER CHIMNEY WHEN FURNACE IS NOT IN USE. - Located left of the chimney cover.
6) WIRING DIAGRAM - Located on rear access cover.
7) ELECTRICAL - Located on the right front corner.
8) SPECIFICATIONS - Located on the front left corner.
1.
2.
DANGER
!
Outdoor Wood Fired Hydronic
CERTIFIED HEATING APPLIANCE
Risk of fire or explosion. DO NOT start or fuel the fire using CSA STANDARD B366-1-M91
garbage, gasoline, drain oil or other flammable liquids or
UL STANDARD 391, UL 762, UL 2523
chemicals. CERTIFIED AS AN ADD-ON MODEL 07/12
WARNING Electrical ratings: volts 120, 1 phase, 60HZ, 15 amps max.
For outdoor use only.
!
Boiler Fuel - Burn wood only.
Shaker Grate Fuel - Coal or Wood
Use only Flue Pipe that is approved by manufacturer.
DOOR AREA MAY BE HOT
Base - Noncombustible, concrete preferred.
Outdoor Wood Fired Hydronic Heater must be kept in good condition, clean
SAFE DOOR OPERATION:
chimney and firebox at end of season. Store wood and all combustible materi-
Door Opening and Closing Instructions:
als outside the installation clearances. Installation clearances: 60" (152 cm)
above/ 48" (122 cm) front/ 6" (15 cm) from sides/ 18" (46 cm) from Flue pipe.
1. Switch blower off.
Keep doors closed tightly.
2. Stand back behind door.
Do not pressurize. Risk of fire or explosion.
3. SLOWLY open door. Do not connect this unit to a chimney flue serving another appliance.
Load fuel carefully to prevent damage to boiler.
4. Wait for smoke to clear (30 seconds).
Do not burn garbage, gasoline, naphta or engine oil.
Close door if smoke continues.
Do not use chemicals or fluids to start fire.
5. Open door fully. Never run boiler with water level below add mark.
Do not leave door open, or dump ash tray close to any combustible materials,
6. After loading, always close and latch door firmly.
may lead to runaway fire.
7. Switch blower on. Refer to owner's manual for complete instructions.
- For safety keep firebox loading door and ash door
tightly closed.
- Follow listed combustible material clearances.
- DO NOT store fuel or other combustible material within
the marked installation clearances of the furnace.
3.
- Inspect and clean flues and chimney regularly.
- Follow complete installation, operating and cleaning
instructions in the Operator's Manual.
CAUTION
MAX. WOOD FILL
!
- Hot surfaces do not touch.
- KEEP CHILDREN at safe distance.
- DO NOT damage furnace. Load wood carefully.
- DO NOT add fuel during a power outage.
- KEEP water level above the add mark.
- Place ash in metal containers and away from
combustible material.
818647R00
2
3
8
1
COZEBURN INSTALLATION AND OPERATION MANUAL
COZEBURN
Heater/Réchau eur Extérieur De Wood red Hydronic
MODEL NO./CERTIFIÉN DE MODÈLE_______________
SERIAL NO./N° DE SÉRIE________________________
CERTIFIÉE COMME MODÈLE COMPLÉMENTAIRE, 07/12
Caractéristiques électriques: 120 volts, courant momphasé, 60HZ, max. de
15 ampères.
For outdoor use only.
Combustible - N'utiliser que du bois.
Shaker Grate Fuel - Coal or Wood
N'utiliser qu'un conduit de fumée approuvé par le fabricant.
Base - Utiliser des matériaux incombustibles, de préférence du béton.
Les appareils de chauffage au bois doivent être maintenus en bon état.
Nettoyer le cheminée et la chambre de combustion à la fin de chaque saison.
Entreposer le bois et toutes les matières combustibles suffisamment loin de
l'appareil. Dégagement minimum: 152 cm (60 po) du plafond, 122 cm (18 po)
à l'avant, 15 cm (6po) sur les côtes et 46 cm (18 po) du conduit de fumée.
Garder les portes fermées hermétiquement.
Faites l'aucun pressurisent.
Do not connect this unit to a chimney flue serving another appliance,
Charger soigneusement l'appareil afin de prévenir les dommages.
Ne pas brûler de déchets, de lessence, du napthe ou de l'huile à moteur.
Ne pas utiliser de produits chimiques, solides ou liquides, pour allumer le feu.
Ne jamais faire fonctionner l'appareil si le niveau de l'eau est inferieur au
niveau de sécurité.
Toujours fermer la porte de l'appareil et ne jamais vider un cendrier près de
matières combustibles. Un incendie peut se déclarer très facilement.
Consulter le manuel du propriétaire pour obtenir des instructions complètes.
Manufactured by Pro-Fab Industries Inc. Fabriqué par Pro-Fab Industries Inc.
FABRIQUÉ AU USA
MADE IN USA
WN00000
TO TOP OF DOOR
818643R00
7
4.
WARNING
818640R00
!
APPAREIL DE CHAUFFAGE
THIS LID IS HEAVY.
NORME B366-1-M91 DE LA CSA
NORME 391, 762, 2523 DE ULC
USE BOTH HANDS.
5.
Note!
• Minimum 5 ft. (1.52 m) of insulated
chimney is required for proper draft.
• Clean chimney outlet regularly.
• Cover chimney when furnace is not
in use.
Refer to Best Burn Practices in Operator's Manual.
6.
818653R00
3 2
4
1
5
6
7
8
Red
9
10
Black Power Line
White Natural Line
7
ELECTRICAL
Electrical Ratings: 120 volts, 60HZ,
max breaker size 15 amps. (Blower
rating is less than 2 amps.)
818643R00
For supply connections use No.14 AWG
or larger wires acceptable for at least
90ºC (194ºF) or equivalent.
For use with aluminum or copper
conductors.
INSTALLATION
ADD-ON INSTALLATION
818645R00
INSTRUCTIONS
- This furnace can be connected to an
existing boiler system.
1. Love Controller
2. Light Switch
- Operate the (oil, gas, electric) boiler
3. Damper Switch
4. Light
5. Probe periodically to ensure it will operate
6. Snap Disc
7. Circuit Breaker satisfactorily when needed.
8. Solenoid
9. Blower - DO NOT relocate or bypass any of
10. Junction Box
the safety controls in the original
boiler installation.
CAUTION: This equipment may only be
installed by qualified personnel.
- Disconnect electric power to both
boilers before servicing.
An annual inspection by a qualified
service technician is recommended.
INSTALLER INFORMATION:
Name__________________________
Address________________________
_______________________________
Line
Line
110 Volts AC
Date of Installation_______________
Ground
818651R00
5
4
6
SAFETY
8.
SPECIFICATIONS
Install and use only in accordance
with the manufacturer's installation/
operating instructions and local
codes. If there are no applicable local
codes, an outdoor installation chimney
must be listed to the ULC-S610 and
ULC-S604 standard. Flue connector
pipe must be made of a minimum 24
NSG black steel. Refer to authorities
having jurisdiction for proper
installation.
Minimum Clearance to Combustibles
Side Wall to Furnace 6" (15 cm)
Back Wall to Furnace 48" (122 cm)
Front of Furnace to 48" (122 cm)
Combustibles
Top of Furnace 60" (152 cm)
Combustibles to Flue 18" (46 cm)
CAUTION
!
- DO NOT connect the unit to a
chimney flue that serves another
appliance.
- DO NOT burn trash in this furnace.
- DO NOT pressurize water in
furnace.
- DO NOT dump ash close to any
combustible materials.
- The heat exchanger, flue pipe,
chimney must be in good condition
and cleaned regularly to remove
accumulated creosote and ash.
- Clean at the end of the heating
season to minimize corrosion
during summer months.
- Follow cleaning instructions in
Operator's Manual.
- Refer to Operator's Manual for
complete instructions.
In the event of loss of electrical power:
1. Open all flow-check and zone
valves in the system. Depending
on system design, this may allow
convective circulation.
2. It is important to remember that
the heating system cannot dispose
of a great deal of heat without
the circulators running. Avoid
over firing! DO NOT LOAD LARGE
AMOUNTS OF SOLID FUEL INTO
THE FURNACE! Fire the furnace
cautiously until it is determined how
quickly the heat system is able to
dissipate the heat being produced
by the furnace.
3. When the power has returned, reset
all flow-check and zone valves and
resume normal operation of the
system.
In the event of a runaway fire:
1. Ensure the firebox door is tightly
closed.
2. Close all the combustion air inlets
on the furnace.
To cool an overheated furnace:
1. Turn all thermostats to their highest
temperature setting.
818655R00
7