Starting The Fire In The Outdoor Hot Water Wood Furnace - Pro-Fab Industries Cozeburn Installation And Operation Instructions Manual

OPERATION
Starting the Fire in the Outdoor Hot Water
Wood Furnace
Once the Cozeburn has been properly installed, all connections
checked thoroughly and the water system is filled to the proper
level, the unit is ready for starting a fire.
1. Place some dry split kindling at the back of the firebox,
on top of some paper, and ignite.
2. Once the kindling begins to burn, add large pieces of
wood until the fire burns briskly. Do not fill the firebox of
the furnace to capacity until the water in the furnace is
hot.
3. Only put enough wood into the furnace as may be burned
during a twelve hour period. Do not fill the firebox above
the top of the loading door.
A small intense fire burns cleaner and is preferable
to long smoldering fires which may create excessive
creosote deposits in the chimney.
DO NOT OPERATE WITH LOADING OR ASH REMOVAL DOORS
OPEN.
DO NOT USE THE DOOR AS A LEVER TO FORCE WOOD INTO
THE FIREBOX!
Note: The Cozeburn has been pressure tested at the factory
for water leaks. Some condensation may be observed in the
firebox while the furnace is heating up after the water has
become completely cold.
18
CORRECT
Wood will burn
cleaner and better if
exhaust passage is
kept open.
INCORRECT
Tightly packed wood
will reduce air flow for
proper combustion.
COZEBURN INSTALLATION AND OPERATION MANUAL