Table of Contents
Advertisement
SAFETY
Safety Alert Symbol
The Safety Alert Symbol identifies
important safety messages in the manual
and on the furnace. When this symbol is
present, be alert to the possibility of injury
or death. Follow all instructions in the safety message
given. This symbol means attention, be alert, and your
safety is involved.
Why is SAFETY important to you? Three very important
reasons:
1. Accidents disable and can be fatal.
2. Accidents cost.
3. Accidents can be avoided.
Signal Words
Note the use of the signal words: DANGER, WARNING
and CAUTION with the safety messages.
The appropriate signal word has been selected using
the following guidelines:
DANGER
DANGER: Indicates an imminently hazardous situation
that, if not avoided, WILL result in death or serious
injury if proper precautions are not taken.
WARNING
WARNING: Indicates a potentially hazardous situation
that, if not avoided, COULD result in death or serious
injury if proper precautions are not taken.
CAUTION
CAUTION: Indicates a potentially hazardous situation
that, if not avoided, MAY result in minor or moderate
injury if proper practices are not taken, or serves as a
reminder to follow appropriate safety practices.
6
Safety Decals
Please read and follow directions to ensure safe
practices when using the Empyre Elite furnace.
1)
DANGER/WARNING/CAUTION
Safety Instructions: Located on the front right
corner below controls.
2)
FURNACE SERIAL DECAL – Located on the right
side front.
3)
ELECTRICAL/INSTALLATION:
Located on top right of the side panel.
4)
CAUTION: Lid area may be very hot. Switch blower
off before opening. Located right of centre back
flue clean out cover.
5)
WARNING: ELECTROCUTION HAZARD. Always
secure door with latch. Tighten with wrench.
Located on centre of rear access cover.
6.
ELECTRICAL WIRING DIAGRAM - Located inside
rear access cover.
7)
SPECIFICATIONS – Located on the upper left corner
on the side panel of the furnace.
Canadian CSA Requirements
Installation of the Empyre Elite as an add-on unit in
the Canadian provinces and territories must comply
with requirements of CAN/CSA-B365, and changes
to the installation must comply with the following CSA
requirements:
CSA B139 - for oil-fired
CSA C22.1 - for electric
CAN/CGA-B149.1 or CAN/CGA-B149.2 - for gas-fired
EMPYRE ELITE INSTALLATION AND OPERATION MANUAL • 2011
Advertisement
Table of Contents
