Table of Contents
Advertisement
Superabrasive
LIFTING THE MACHINE FROM WORKING TO TOOL MOUNTING POSITION
Figure 3.5
LIFTING
Lifting the machine by crane is possible by using the eye bolt mounted on the carriage
(see fig. 3.7). The eye bolt and machine construction is rated only for the weight of the
machine. Do not lift any other loads on the machine. Use always hoisting equipment
rated for 300 kg or 660 lbs.
STORAGE
Always store and transport the LAVINA® S machine in a dry place. Never transport the
LAVINA® S machine unprotected; it may be damaged if transported unprotected
during rain or snow.
When during the storage of the machine the temperature may fall
down to or less 32F (or 0
‐
Pull out the hose of the tank (Fig.3.8)
‐
Using compressed air blow out the water from the system for the two positions of the turn‐cock (Fig. 3.9, Fig. 3.10).
Figure 3.8
MOUNTING OF GUARD ASSEMBLY
Set the machine in the position shown on Fig 3.11, turn the Guard Assembly (Fig 3.12). Pull backwards the Guard Assembly, you
have to be sure that the Tool holders have passed through it (Fig 3.13). Put the Guard Assembly on position (Fig 3.14).
Dismounting must be done in reverse sequence.
Fgure 3.11
User Manual
Figure 3.6
Figure 3.6.1
o
C) you should empty the water from the system using following steps:
Figure 3.9
Fgure 3.12
Original Language
Lavina® 30G‐S
Push the front handle down and swivel it to
the front (Fig. 3.5). Pull the handle up and
ensure the head is a stable upright position,
for mounting/dismounting the tool. Ensure
that the water tank is empty before flipping
the machine. Pull the head in upright
position(Fig. 3.6).
The machines manufactured after 2013 are
with `changed locking of the front handle as
shown on the fig.3.6.1.
Figure 3.10
Fgure 3.13
9
6/2014
Figure 3.7
Fgure 3.14
Advertisement
Table of Contents
