Flipping The Machine Up; Splitting The Carriage From The Mainhead; Lifting - lavina 32-S-E User Manual

®
Superabrasive Owner's Manual Original Language – Lavina 32-S-E 6/2013

FLIPPING THE MACHINE UP

To change the tools put the handle in the flipping (upright) position (Fig. 3.11), grab the steering bracket and pull the
machine with all your bodyweight down (one foot on the control box can help) Put the bracket down on the floor (Fig.
3.12) and change tools. While putting the machine down a foot on the control box helps again.
Figure 3.11 Figure 3.12

SPLITTING THE CARRIAGE FROM THE MAINHEAD

Figure 1.13 Figure 1.14 Figure 1.15
Figure 1.16 Figure 1.17 Figure 1.18
Unplug the motor cable plug from the control box (Fig. 3.13) and disconnect the water hose from the main head by
pulling it out (Fig. 3.14) and (Fig. 3.15). Release the pin sets (Fig. 3.16) which attach the head to the carriage and
divide the carriage from the main head (Fig. 3.17).

LIFTING

Lifting the machine by crane is possible by using the hoisting ring mounted on the carriage (see Fig.3.18). The eye bolt
and machine construction is rated only for the weight of the machine. Do not lift any other loads on the machine. Use
always hoisting equipment rated for 450 kg or 1000 lbs. See to it the security pin (Fig. 3.9, Fig. 3.10) is mounted.
7