Switching Off The Lights - Renault LAGUNA Handbook

EXTERIOR LIghTINg ANd sIgNALs
2
directional headlights
Depending on the vehicle, with the
dipped beam headlights on and under
certain conditions (speed, steering
wheel angle, forwards gear selected,
etc.) when cornering, the dipped beam
headlights move to light the inside of
the bend.
Operating faults
When the message "check lighting" ap-
pears on the instrument panel along
©
with warning light , this indicates
that there is a lighting fault.
Consult an approved dealer.
1.66
(continued)
special note:
– If the dipped beam headlights are
1
manually switched on and if the light
is sufficient, the directional head-
lights will remain fixed;
– If the lights come on automatically
when cornering, the directional head-
lights will start working from the next
time the vehicle corners;
– When the dipped beam headlights
are switched on with the engine run-
ning and the vehicle stationary, the
lights move to reinitialise themselves.
If not, there is a system fault.

switching off the lights

There are two possibilities:
– Manually, move ring 2 to position 0;
– automatically, the lights will go out
when the engine is switched off, the
driver's door is opened or the vehicle
is locked. In this case, the next time
the engine is started the lights will be
switched back on according to the
position of the ring 2.
"see-me-home lighting"
function
This function allows you to briefly switch
on the dipped beam headlights (to pro-
vide light when opening a gate, etc.).
With the engine and lights off and
ring 2 in position 0, pull stalk 1 towards
you: the dipped beam headlights come
on for approximately thirty seconds.
To increase this duration, you may pull
the stalk up to four times (total time re-
stricted to two minutes). The message
"lighting for_ _ _" along with the times
the lights will be on for is displayed on
the instrument panel to confirm this
action.
To switch off the lights before they go
out automatically, turn ring 2 to any po-
sition, then return it to position 0.