1. Power Button – Press and release the
1. Power Button –
1. Power Button – Press and release the
Power Button to turn the TeraStation on. Hold it
down for 3 seconds to turn the TeraStation off.
2. USB Ports –
2. USB Ports – USB ports on both front and
2. USB Ports – USB ports on both front and
rear panels of the TeraStation may be used
to connect USB hard drives, a printer, or an
additional TeraStation to your TeraStation. See
TeraStation Expansion on page 17 for more
information on using TeraStation's USB ports.
3. Hard Drive Status (also 5, 8, and 10) – This LED will glow green when the corresponding hard
3. Hard Drive Status (also 5, 8, and 10) –
3. Hard Drive Status (also 5, 8, and 10) – This LED will glow green when the corresponding hard
drive is detected at boot, and will blink green when a disk check or format is in process. It will glow red
drive is detected at boot, and will blink green when a disk check or format is in process. It will glow red
when the hard drive is 90% full or more, and blink red if there is a problem with the drive.
4. Hard Drive Access (also 6, 7, and 9) – This LED will blink green when the associated hard drive
4. Hard Drive Access (also 6, 7, and 9) – This LED will blink green when the associated hard drive
4. Hard Drive Access (also 6, 7, and 9) –
is accessed. During startup, it's normal for all the lights on the front panel to light up in order, producing a
pinwheel effect.
page 17
page 17 for more
This LED will glow green when the corresponding hard
18
TeraStation Diagram