To Operate The Speed Control - KitchenAid Ultra Power Plus Instructions And Recipes Manual

TO OPERATE SPEED CONTROL
WARNING
!
Injury Hazard
Unplug mixer before touching
beaters.
Failure to do so can result in
broken bones, cuts or bruises.
Note: With the Power Switch in the ON
position, an accidental touching of the
speed control, or other circumstances
may result in turning on the mixer. If
mixer runs when "0" speed is flashing,
do not use; call 1-800-541-6390 to
arrange for service.
• Be certain the Power Switch is in the
OFF position.
How to Use the Mixer
10
• Plug mixer into electrical outlet.
• Press Power Switch to ON position.
ON/OFF Power Switch controls power
to motor and control panel. The
Speed Indicator light will flash "0";
this light flashes when the mixer is
plugged in and ready to operate.
• Press RUN and unit runs until you
press STOP. Upon pressing STOP,
the unit automatically returns to "0"
speed.
• To increase speed, press RUN.
• To decrease speed, press the DOWN
ARROW.
• Press STOP when you want to stop
the mixer, when mixing time stated in
the recipe has been reached, or when
ingredients have reached the desired
consistency. When you press STOP
the mixer will stop operating and the
"0" will flash again, indicating that
power is supplied to the control panel
and the unit is ready to operate. DO
NOT touch beaters. DO NOT use the
STOP pad as a substitute for the
Power Switch.
Note: The speed indicator will return to
"0" during any of these power
interruptions:
• Pressing the Power Switch to OFF
position
• Power failure
• Unplugging unit