Connecting Power (If Required); Configuring Your Scanner - Symbol LS 4008i Product Reference Manual

LS 4008i Product Reference Guide

Connecting Power (if required)

If your host does not provide power to the scanner, you will need an external power
connection to the scanner:
1. Connect the interface cable to the bottom of the scanner, as described in
the Interface Cable
2. Connect the other end of the interface cable to the host (refer to your host manual
to locate the correct port).
3. Plug the power supply into the power jack on the interface cable. Plug the other
end of the power supply into an AC outlet.

Configuring Your Scanner

Two methods are available to configure your scanner: using the bar codes included in this
manual, or the 123Scan configuration program.
Refer to Chapter 4, User Preferences
using bar code menus. Refer to
configuration program. A helpfile is available in the program.
The scanner supports RS-232, IBM 468X/469X, Keyboard Wedge, Wand Emulation, USB,
and Synapse to interface to a host system. Each host specific chapter describes how to set
up each of these connections.
1-4
on page 1-3.
for information about programming your scanner
Chapter 10, 123Scan to configure your scanner using this
Installing