Troubleshooting Printer Hardware - Canon PIXMA iP6600D Series Quick Start Manual

Troubleshooting
Troubleshooting Printer Hardware
Problem
I
Possible Cause
I
Try This
Printer Does Not Ink tank is empty
Start or Printer
Stops During
Print Jobs
Ink tank is not
installed in the
correct position
Ink tank is not fully
inserted
If the ink tank lamp is flashing fast, ink is empty. Replace the ink tank·and close
the cover. If printing is not finished yet, just press the OK button on the printer to
continue printing in the "no ink" state. Replace the ink tank as soon as possible
after printing finishes.
Continuing to print in the "no ink" state may cause damage to the printer. Refer to
"Replacing an Ink Tank" in the
Direct Printing Guide.
WNote If multiple ink tank lamps are flashing, check how fast they flash. Fast
flashing (at about a second interval) indicates the ink is empty. Slow
flashing (at about three second interval) indicates ink is low. For
details on different flashing speeds, Refer to "Getting the Ink Level
Information" in the
Direct Printing Guide.
If an ink tank lamp is flashing even though ink remains in that ink tank, it is
inserted in the wrong position. Make sure that the correct ink tank color is inserted
in each position. Open the cover and make sure all the ink tank lamps are lit.
Refer to "Replacing an Ink Tank" in the
Direct Printing Guide.
When the ink tank lamp is unlit, press the
8
mark on the ink tank until it clicks
into place. The ink tank lamp lights red when the ink tank is fully inserted.
Make sure all of the orange tape is peeled off the ink tank as illustrated in Figure 1.
If any orange parts are left like in Figure 2, remove all of the orange parts.
(1) Correct
An L shaped notch
appears on the in k
tank.
(2) Incorrect
There remains the
orange tape. Peel off
the tape completely
along the perforation.
39