Canon PIXMA iP6600D Series Quick Start Manual page 133

Ink Error/No ink
Hardware Error/No ink
Printer error
You can check the printer status according to the way the ink tank lamps (red)
flash. Check the status of the lamp and take the appropriate action to clear the
error.
• When the ink tank lamp is off, possible causes are as foHows:
• The ink tank may not be installed properly.
Install the appropriate ink tank.
• The ink tank may not be compatible with this printer.
Install the appropriate ink tank.
See "Replacing an Ink Tank" on page 50 .
• When the ink tank lamp flashes fast (at about one second interval), possible
causes are as follows:
• The ink has run out.
Replace the ink tank, and dose the cover.
If printing is in progress and you want to continue printing, select Continue*l
in the display on your camera with the ink tank installed. Then printing can
continue under the ink out condition. Replace the empty ink tank immediately
after the printing. The printer may be damaged if printing is continued under
the ink out condition.
WNote
If multiple ink tank lamps are flashing, check how fast they flash. Fast flashing
(at about one second interval) indicates the ink is empty. Slow flashing (at
about three second interval) indicates ink is low. For details on different
flashing speeds, see "Getting the Ink Level Information" on page 50.
• Some ink tanks are not installed in place, or more than one ink tanks of the
same color are installed.
Confirm that the ink tanks are installed in the appropriate positions.
See "Replacing an Ink Tank" on page 50.
The ink tank that was once empty is installed.
Replace the ink tank.
Printing under the situation may damage the print head. Canon shall not be liable
for any printer malfunction or damage caused by refilled ink tanks.
If you want to continue printing with the refilled ink tank installed, press and hold
the Stop/Reset button for at least five seconds, and then release it. Using refilled
ink tanks are memorized.
*
This operation will release the function for detecting the remaining ink level.
The ink tank errors have occurred.
Replace the ink tank.
See "Replacing an Ink Tank" on page 50.
An error requiring servicing might have occurred. (Printer POWER lamp and Alarm
lamp flash alternately.)
Disconnect the cable between the printer and the camera, turn off the printer, and
unplug the power cord of the printer from the power supply. After a while, plug the
power cord of the printer back in, turn on the printer, and then reconnect the
camera to the printer.
If the same error occurs, contact the Customer Care Center.
*1
To resume printing, you can press the OK button on the printer instead of selecting Continue.
*2
The waste ink absorber absorbs ink used during cleaning, for example. If this message
appears, you will need to call for servicing to replace the absorber and to check the printer for
proper operation.
7 1