Power Lamp And Alarm Lamp Flash Alternately; Cannot See The Display Properly On The Lcd/Cannot See The Display On The Lcd - Canon PIXMA iP6600D Series Quick Start Manual

WNote
Adjusting the Print Head Manually
If the automatic print head adjustment does not work or if you wish to adjust
the print heads manually, follow the procedure below.
1. With the printer on, load two sheets of A4/Letter-sized plain paper in the
auto sheet feeder.
2. Press the Menu button.
3. Use the
~ ~
buttons to select Maintenance/settings and then press the OK
button.
4. Use the
~ ~
buttons to select Maintenance and then press the OK button.
S.
Use the •
~
buttons to select
Manual head align
and then press the OK
button.
6. When the confirmation message is displayed, use the •
~
buttons to select
Yes and then press the OK button.
The print head alignment pattern will be printed.
7.
The message of "Did the patterns print correctly?" is displayed on the LCD.
Ensure that the patterns were printed normally and use the •
~
buttons to
select Yes and then press the OK button.
I
"Millttmlmllt0j,
8. Examine the printed pattern and enter the number of
;~:e;a~~:r~u~~~rf:~est
column "A" with fewest white stripes using the
~ ~
white stripes.
butt
0
ns.
01/10
9. Use the
~
button and move the cursor to column "8",
and use the
~ ~
buttons to select the number with
fewest white stripes.
10. Repeat same procedure and enter the pattern
numbers up to column
"J".
11. After setting the number of all column, press the OK
button.
II
POWER Lamp and Alarm Lamp Flash Alternately
Possible Cause
I
Try This
An error that requires contacting
the Customer Care Center may
have occurred
Disconnect the printer cable from the printer, and then turn the printer off and
unplug the printer from the power supply. Plug the printer back in and turn the
printer back on after leaving it for a while.
If the problem remains, contact the Customer Care Center.
II
Cannot See the Display Properly on the LCD/Cannot See the Display
on the LCD
Possible Cause
I
Try This
Cannot see the display properly
on the LCD/
The display on the LCD is illegible
Cannot see the display on the LCD
62
Adjust the contrast of the LCD in the Adjust contrast menu in the Maintenancel
settings. See "Changing the Other Settings" on page 33.
The LCD may be in the sleep mode.
Press the OK button to turn on the LCD again.
*
If you leave the printer more than five minutes without using any button on the
operation panel, the LCD goes into the sleep mode automatically.