Power Lamp And Alarm Lamp Flash Alternately; Cannot See The Display Properly On The Lcd/Cannot See The Display On The Lcd - Canon PIXMA iP6600D Series Direct Printing Manual

Adjusting the Print Head Manually
If the automatic print head adjustment does not work or if you wish to adjust
the print heads manually, follow the procedure below.
1. With the printer on, load two sheets of A4/Letter-sized plain paper in the
auto sheet feeder.
2. Press the Menu
3. Use the
button.
4. Use the
5. Use the
button.
6. When the confirmation message is displayed, use the
Yes and then press the OK Yes
Yes Yes
The print head alignment pattern will be printed.
7. The message of "Did the patterns print correctly?
Ensure that the patterns were printed normally and use the
select Yes

POWER Lamp and Alarm Lamp Flash Alternately

Possible Cause
An error that requires contacting
the Customer Care Center may
have occurred
Cannot See the Display Properly on the LCD/Cannot See the Display
on the LCD
Possible Cause
Cannot see the display properly
on the LCD/
The display on the LCD is illegible
Cannot see the display on the LCD
62
Menu button. Menu Menu
buttons to select Maintenance/settings
buttons to select Maintenance
buttons to select Manual head align
OK button.
OK OK
Did the patterns print correctly? Did the patterns print correctly? Did the patterns print correctly?" is displayed on the LCD.
Yes Yes and then press the OK Yes
8. Examine the printed pattern and enter the number of
column "A" with fewest white stripes using the
buttons.
9. Use the
and use the
fewest white stripes.
10. Repeat same procedure and enter the pattern
numbers up to column "J".
11. After setting the number of all column, press the OK
button.
Disconnect the printer cable from the printer, and then turn the printer off and
unplug the printer from the power supply. Plug the printer back in and turn the
printer back on after leaving it for a while.
If the problem remains, contact the Customer Care Center.
Adjust the contrast of the LCD in the Adjust contrast
settings. See "Changing the Other Settings" on page 33. settings settings settings
The LCD may be in the sleep mode.
Press the OK OK button to turn on the LCD again. OK OK
* If you leave the printer more than five minutes without using any button on the
operation panel, the LCD goes into the sleep mode automatically.
Maintenance/settings and then press the OK Maintenance/settings Maintenance/settings
Maintenance and then press the OK Maintenance Maintenance
Manual head align and then press the OK Manual head align Manual head align
OK button. OK OK
button and move the cursor to column "B",
buttons to select the number with
Try This
Try This
Adjust contrast menu in the Maintenance/ Adjust contrast Adjust contrast
OK OK OK
OK button. OK OK
OK OK OK
buttons to select
buttons to
OK OK OK
Maintenance/ Maintenance/ Maintenance/