BMW K 1600 GT Installation Manual page 4

Re-installing Lock &
Switch into Sargent
Switch Plate
K 1600 GT / GTL
K 1600 GT owners can skip lock
and switch installation of this step
if re-using OEM switch plate.
Note: You may have to rotate the
latch rod back and forth slightly
while you slide the switch plate
assembly in place to allow the
lock barrel to properly engage
into the latch rod.
SARGENT CYCLE PRODUCTS, 1036 HUBBARD STREET, JACKSONVILLE, FL 32206 PH: (904) 354-4531 FAX: (904) 354-7979
From the front of the switch plate, insert OEM lock with the three spring-loaded
bars on the lock body shown facing the curved edge of the switch plate as shown.
From the front of the switch plate, insert OEM heat switch into the switch plate
until it's firmly in place.
On the rear Sargent Seat, locate the 4-pin plug and plug it into the switch mounted
onto the switch plate as shown.
Install switch plate by guiding the
lock barrel tab into the end of the
latch rod as shown.
Once the lock tab is fully engaged
with the latch rod, the screw holes
in the switch plate and pan should
line up. Hold switch plate in place
while installing the screws.
Gently snug the screws. Do not over
tighten. Over tightening may strip
the threads.
BMW K 1600 GT / GTL SEAT INSTALLATION GUIDE
Lock barrel (left) fits into the notched latch rod (right).
4