Lock Removal - BMW K 1600 GT Installation Manual

Lock Removal

K 1600 GT
K 1600 GT owners can skip this
step if re-using OEM switch plate.
K 1600 GTL
Take note of the position of the
three spring-loaded bars on top of
the lock barrel as it comes out of
the switch plate shown.
The lock must be re-installed in
the same position during re-
assembly. These three bars
pointed toward the bottom edge of
the switch plate.
SARGENT CYCLE PRODUCTS, 1036 HUBBARD STREET, JACKSONVILLE, FL 32206 PH: (904) 354-4531 FAX: (904) 354-7979
Using a small pointed object like
a paper clip, gently press in the
lock's retaining key through the
hole in the switch plate located
under the lock to release it.
Slide the lock barrel free and out
of the switch plate.
Set lock aside.
Take note of the position of the three spring-
loaded bars on top of the lock barrel as it comes
out of the switch plate shown.
The lock must be re-installed in the same position
during re-assembly with these three bars pointed
toward the bottom edge of the switch plate.
Once the switch plate is removed, grasp
the lock bracket (still attached to the OEM
seat via the cable release).
Using a flathead screw driver, gently
press the lock's retaining key while
pressing the lock's barrel toward the key
opening with your thumbnail as shown.
Slide the lock barrel out of the bracket as
shown. The lock will come out all in one
piece.
Set lock aside.
BMW K 1600 GT / GTL SEAT INSTALLATION GUIDE
3