BMW K 1600 GT Installation Manual page 2

Switch Plate Removal
K 1600 GT
Note: K 1600 GT owners may re-
use OEM switch plate on Sargent
Seat or Sargent switch plate
provided with your new Sargent
Seat.
K 1600 GTL owners must use
switch plate as provided by
Sargent.
K 1600 GTL
K 1600 GT and GTL
SARGENT CYCLE PRODUCTS, 1036 HUBBARD STREET, JACKSONVILLE, FL 32206 PH: (904) 354-4531 FAX: (904) 354-7979
Remove switch plate on
the stock seat by removing
5 screws shown using a
Phillips head screwdriver.
Unplug electrical connector attached to heat switch behind switch plate.
BMW K 1600 GT / GTL SEAT INSTALLATION GUIDE
Remove switch plate on the stock seat
by using a size T20 Torx to remove 3
screws shown.
Using a flathead screw driver, remove
the heat switch by gently pressing the
retaining fingers on each side of the
heat switch towards the body of the
switch to release it from the switch
plate as shown.
Gently push the switch out of the
switch plate, from the back towards
the front until the switch is removed.
Set switch aside.
2