Rear Seat Installation - BMW K 1600 GT Installation Manual

Rear Seat Installation

K 1600 GT / GTL
Note: Make sure the 2-pin heat
seat connector, attached near the
front of the rear seat, is extended
out toward the front of the bike.
This will connect to the front seat
after the rear seat is secured.
SARGENT CYCLE PRODUCTS, 1036 HUBBARD STREET, JACKSONVILLE, FL 32206 PH: (904) 354-4531 FAX: (904) 354-7979
Sargent now provides Plug and Play heat plugs
specifically for your BMW. However, the way the
two-piece Sargent Seat heat connectors attach to your
bike is slightly different than your OEM one piece
seat. This guide will familiarize you with this process.
With your OEM seat removed, locate the 6-pin master
receptacle on your motorcycle. Plug this receptacle
into your new Sargent rear seat connector.
Once your rear seat is connected, you must install
your rear seat before connecting and installing the
front seat.
Insert the seat, rear first, so the seat captures (flanges on left image) are under the
metal tabs (on right image). Take care not to pinch any wiring.
Next, locate the two OEM threaded inserts located on the frame on either side of
the battery.
Using the two thumb screws included with your Sargent Seat, secure the front of
the rear seat through the bushings into threaded holes on the frame. Tighten the
thumb screws until snug.
BMW K 1600 GT / GTL SEAT INSTALLATION GUIDE
6