Mode For Checking The Load On The Jog Dial - Pioneer CDJ-1000MK3 Service Manual

1

6.2 MODE FOR CHECKING THE LOAD ON THE JOG DIAL

A
• It is the mode which judges the load (light/-- heavy) numerically when rotating JOG dial.
JOG Check Mode : ON
TOUCH/BRAKE
B
Maximum position
(fully clockwise direction)
Measuring method
Enter this mode, and a number will be displayed if JOG dial is turned with sufficient vigor. The rotation direction -- clockwise
direction and counterclockwise direction -- either is O.K.
For example, when displayed as "JOG 8.6: 115msec", the following contents are shown, respectively.
8.6 = What time speed came out by the highest. (The time of turning one rotation in 1.8 seconds is made into 1 time.)
115 = Time taken for rotation to fall by 1.5 times from 3 times (msec)
C
It is necessary to make it rotate top speed to 7.0 or more times to measure the rotation fall time required.
When it carries out continuously several times, the time which took the average with a part for greatest ever 4 time is
displayed 2nd henceforth.
Measurement which absorbed variation can be performed by performing this.
Jog Management Value : 150 ± 25 (msec)
Load adjustment method
Remove the screw fixing the adjust plate, then screw it into the hole corresponding to the value (-1, -2, -3, +1, or +2) for a
load to be added:
-1, -2, -3 : To decrease the load
D
+1, +2 : To increase the load
Adjust plate
-3
-2 +2
To decrease
-1
+1
the load
0
E
JOG Check Mode : CANCEL
POWER OFF
F
78
1
2
Mode for checking the load on the Jog dial
JOG
It judges by the 3rd measured value.
To increase
the load
CDJ-1000MK3
2
3
0 . 0 : 0msec
Top speed Time (msec)
3
4
JOG ADJUST
Centrepoint
4