Plumbing - Equator EZ 4000 CV Owner's Manual

CONNECTING TO THE WATER FAUCET
Please read the following steps carefully
1. Connect the straight end of the hot-water hose to the hot-water faucet (Fig.5)
2. Connect the straight end of the cold-water hose to the cold-water faucet (Fig.5)
3. Connect the L-shaped end of the hot-water hose to the inlet valve marked "H" (Fig.6)
4. Connect the L-shaped end of cold-water hose to the inlet valve marked "C" (Fig.6).
CONNECTING THE DRAIN HOSE
Connect the drain hose to a drain duct (with internal diameter of at least 1.6 inches) or place
it for drainage in to a sink or a tub, ensuring that there are no kinks or bends. The free end
must be at a height of 24"-40" from the floor. The hose can be held in place using the black
plastic clamp on the upper part of the back panel (Fig.6)
Cold
water
faucet
(Fig.7)

PLUMBING

Hot
water
faucet
(Fig.5)
Height difference between the installation location of
the washing machine and the drainage point:
Minimum 24", and Maximum 40".
- Attach water drain hose to U-Connector.
- Hook the U-Connector over the side or stand pipe (Fig 7.)
- When the water is being drained, check
that the water flow out of the hose is
adequate.
10
C
H
(Fig.6)