Table of Contents
Advertisement
SECTION 10 – SLIDEOUT ROOMS AND LEVELING
SLIDEOUT ROOM LOCK
SYSTEM
–If Equipped
If your vehicle is not equipped with a slideout
room keylock, then the ignition key must be
placed in the on or run position to operate the
slideout room(s). The park brake must be applied
for the room(s) to run. Winnebago recommends
running the engine whenever you run the slideout
rooms in or out, the engine alternator should
insure the rooms have adequate 12-volt DC
power to operate correctly.
SLIDEOUT ROOM TRAVEL
LOCKS - ELECTRIC
–If Equipped
Some models are equipped with electric
Slideout Room Travel Locks on slideout rooms
to restrict movement of the slideout room while
the vehicle is in motion. The slideout room will
not extend until the lock is fully released.
Slideout Room Travel Lock switches are
located on a wall in an area near the slideout
room or incorporated into the monitor panel,
depending on model.
Slideout Room Travel Locks
(Your model may be equipped
with one or more types)
-Typical View
NOTICE
Release Slideout Lock before attempting
to extend slideout room. The room will not
extend until the lock is fully released.
Fasten Slideout Lock before driving
vehicle. See following instructions.
NOTE: Be sure locks are fully released before
attempting to extend or retract room.
If the latch mechanisms are protruding
more than 1/4", the room will not extend
or retract.
To Release
•
Press and hold the UNLOCK side of the
Slideout Room Travel Lock switch for
approximately 7 seconds. (You may be able to
hear the lock motor sound stop).
To Lock
•
Press and hold the LOCK side of the Slideout
Travel Lock switch for approximately 7
seconds. (You may be able to hear the lock
motor sound stop).
Slideout Lock Drain Line
If your coach is equipped with electric
Slideout Room Travel Locks, it is recommended
to periodically inspect the slideout lock drain line
(located near the top of the exterior slideout
room).
NOTE: Depending on the length of your slideout
room, there may be two Slideout Room
Travel Locks. Therefore, two drain lines
will need to be inspected (typically one
located on each end of the slideout
room).
It is possible for dirt and debris to collect
inside the drain line and cause obstruction, not
allowing water to drain properly. If the drain line
is plugged, use a small tool (i.e. pipe cleaner) to
10-1
Advertisement
Table of Contents
Troubleshooting
