Winnebago Tour 2014 Owner's Manual page 110

SECTION 7 –
PLUMBING
Diverter Plug
(Model 42GD only)
NOTE: The filtered water faucet/ice maker filter
on Model 42QD has a built-in bypass.
No separate diverter plug is required.
2. Remove the filter canister from the full-coach
water filtration system in the water service
center and discard the filter cartridge.
After removing filter, remount the empty
canister onto the filter assembly and continue
the antifreeze fill procedure.
3. Turn Winterization Valve 2 to the "Winterize"
position.
Winterization Valve 2
(Located near water pump - second
compartment on driver side of coach)
4. Remove and save the protective cap from the
end of the antifreeze siphon tube (which
connects to Winterization Valve 2). Insert the
end of the siphon tube into a pail or other
container with 2 to 5 gallons of non-toxic RV
antifreeze solution.
7-16
RV Antifreeze Siphon Tube
(Located in the third compartment on
passenger side of coach)
• Insert into container of RV water system
antifreeze
NOTE: Ensure that all drain valves are
CLOSED before pumping RV antifreeze
into the water system.
Refer to the "Water System Drain Valve
Locations" chart at the end of this
section for valve locations on your
model.
Fill Lines
5. Turn the Water Pump switch ON.
6. Open each hot and cold water faucet handle/
knob in the coach – one at a time each in turn
until antifreeze solution just begins to flow
from the faucet, then close.
Do not forget exterior shower/wash station
knobs.
7. Press the toilet flush pedal (or the "Normal
Flush" button on the wall control, if your
coach is equipped with an electric flush toilet)
and hold until antifreeze begins flowing into
the toilet.
Leave small amount of antifreeze that remains
in the bowl.
When Done Adding RV Antifreeze
8. Turn the Water Pump switch OFF.
9. Turn the Winterization Valve 2 to "Normal".
This will stop the flow from the antifreeze
siphon tube and revert the tank line flow to the
water pump.
.