Remote Control Initial Set-Up - Valor 700IN Owner's Manual

The receiver and the handset of the remote control
system must be initially synchronized before the fi rst
use.
1. Remove the cover of the battery box (1 screw).
Remove cover
2. Insert alkaline batteries in the battery box and
handset.
3. Refi t the cover and secure with the screw.
4. On the left hand side of the fi rebox, pull the loose
wire that is already connected to the receiver and
connect it to the battery box. Place the battery box
upside on the left of the fi rebox.
Connect battery box to wire

Remote Control Initial Set-up

5. With a sharp object, press and hold the receiver's
6. Within the subsequent 20 seconds, press the (small
This is a one time setting only and is not required when
changing the batteries in the remote receiver. The
remote control system is now ready to use.
reset button until you hear one short and one long
beep. Release the reset button after the second
beep.
Battery
box
Battery box connection
Battery box
fl ame button ( ) on the remote handset until you
hear two short beeps confi rming the synchronization
is set.
QUALIFIED
INSTALLER
Reset
button
35