Remote Control Installation - Valor 530XAN/XAP Installation Instructions Manual

Caution! Do not connect the batteries to the
remote control receiver until the wires are
connected to the burner control unit, as a
short circuit could result in the destruction of
the electrical components.
• Connect the wiring harness to the receiver box, by
pushing the wire connector on to the receiver circuit
board. The plug will only go on one way so please
ensure that the wires are pointing up and slot in the
board is in line with the tab on the wiring harness plug
• Connect wires as shown below.
Please note that the "L" connectors are different sizes,
the smaller one fi ts to the lower connection on the
valve. The other wire connectors can be fi tted to either
terminal .
• Remove the remote control receiver lid.
• Fit four 1.5V batteries.
• Place the remote control receiver on the "Velcro" pad.
• Fit the 9V battery to the handset transmitter
Remote control operating instructions are on
pages 28–29 of this manual and are supplied with the
remote control kit.
Receiver

Remote Control Installation

Push-on
Connector
Valve
21 21